Commercial Polishing of Tiles
For really stubborn grout, you can use a toothbrush to scrub it. For stains or darkened grout, sprinkle baking soda over the grout, then spray white vinegar over it. Let the baking soda and vinegar sit for 5 minutes, then scrub the grout with your toothbrush.
Mop the floor with warm water and 1 to 2 drops of dish soap. A little bit of dishwashing soap goes a long way. One to two drops is plenty for 1 gallon (3.8 L) of warm water. Dip your mop into the bucket and slosh it around a bit to get the water nice and sudsy. Then wring the mop into the bucket to remove any excess water.
Start at one part of the room and work your way across the entire floor, mopping in big sweeping motions. It’s best to use as little soap as possible when cleaning your tile because excess soap can leave a residue on the tile. Make sure the bucket is large enough to hold 1 gallon (3.8 L) of water without sloshing over the sides.
The bucket itself should be clean to start with as well. You don’t want to start by adding more dirt to your soapy water! When you are finished mopping, clean your mop by rinsing with clean water so that it doesn’t harden and build up dirt. Allow the tile floor to fully dry. When you have finished mopping the floor, empty the bucket and rinse out any residue to give your floor some time to dry.
It’s very important to let your tile dry completely before you do anything else to it. Wet tile will make it difficult to add any cleaning solutions or to buff the tile. Wait at least 1 hour to let your floor dry. You can use a fan in the room to help your floor dry quicker.
