How Installing Your New Tiles?
Comb the thin-set onto the floor. Dip your trowel into the bucket of thin-set and spread it out across the floor. Move your trowel in the same direction, to reduce the possibility of air pockets. If there were low spots in the floor that you marked earlier, you may need to apply extra thin-set to those areas.
Set each calacata tile down and wiggle it a bit. Hold the new slate tile above its future spot and drop it down gently and slowly. Move it just a bit side-to-side to secure the tile to the floor. Tap the top of the tile with a wooden hammer as well. Place a level on top of the tile to verify that the wood marble tile is level. Continue until all the tiles are placed.
Thin-set starts to dry immediately. If you need to peel up a tile and move it, you’ll need to do so almost immediately or risk having to chisel away hardened thin-set. The thin-set will be totally dry within 24-48 hours.
Use a tile cutter to make smaller tile pieces. You can either rent a cutter or buy a hand-held one from a home improvement store. You’ll likely need to cut crystal tiles to complete the edges of your floor. Hold a full cement tile under the cutter and run the scoring wheel across the top. Next, push down on the cutter’s handle until the tile snaps along the scoring line. Other options for cutting tile include using a wet saw or glass cutting tool.
Inspect each section of black tile before moving on. After you finish four or more tiles, stand up and take a few steps back. Look down to see if the amazon tiles appear in proper alignment. Place a level across the only tiles to make sure it is even. Take this opportunity to clean away any thin-set from the tile’s surface with a damp sponge as well.
Work the grout into the joints. When all of the tiles are placed, mix your grout in a bucket according to the package directions. Use a trowel and grout float to press the grout in between each tile. Wipe away any excess from the tile’s surface before it hardens by using your trowel and a sponge. When you are finished, let the grout dry for two days before walking on it. Don’t add too much water to your grout. It should be similar in texture to cake batter.
