Posts

How Mopping Your Floor?

/in /by

Use hot water. Whether you are creating a solution to wash your floor, or just using water, you should use hot water. Hot water will help cut through grime. Ultimately, by using hot water, you’ll decrease the chance that you’ll need tougher solvents that could damage the marble.


Focus on distilled water. Distilled water is water that has gone through a process to remove minerals and other impurities. By using distilled water, you’ll reduce the chance of discoloring or staining your marble. You can buy distilled water at just about any grocery store or box store. It is usually cheap.


Add a mild detergent to your water. Add a mild detergent such as 2-3 drops of dish soap into a bucket with your hot, distilled water. Follow the directions of the soap and dilute it with an appropriate amount of water. Mix your solution thoroughly. Make sure to only add pH neutral soap to your water.


Harsh chemical solutions like bleach, hydrogen peroxide, ammonia, and vinegar can be damaging to your floors. Avoid using these on marble. If you prefer, you may be able to use a commercially prepared marble cleaner. Simply follow the directions on the bottle and then clean as you would with a water and detergent solution. Some products include Stone Tech, Resolve, or Simple Green.


Use a soft mop on your floor. Take a mop with a soft mop head (preferably microfiber) and dip it into your solution of detergent and water. Wring out the mop head to relieve it of excess water and systematically mop your floor. Do short strokes that overlap. Rinse and wring out the mop head after you’ve covered 10 to 20 square feet (1 to 2 square meters). This might vary depending on how dirty the floor is.

How Does Ceramic Tile Spread Stick Relatively Firm?

/in /by

How should ceramic tile put up? It might seem simple, but it’s not. Should pay attention to all sorts of the skill of tiling and the use of auxiliary material, ability lets ceramic tile affixed more firmly, the surface is more beautiful. Today come with ceramic mesh to study together, ceramic tile laid how to be more secure.

1.Avoid ceramic tile water absorption rate excessive choose ceramic tile, need key check the water absorption rate of ceramic tile. Drop the water on the back of the tile to see how fast the water will soak. In the same way, the slower the absorption, the greater the density of the tile.
2.Avoid the tiling of the tile on the back of the tile to fit tightly with the wall, and the back of the tile will generally be designed. When the grain is deep, it can ensure that the tile and cement mortar layer will not fall off when it happens.
3.Sand is best chosen for sand and sand, the deployment of the cement mortar strength is higher, but if the strength is too high, can also lead to some bad results, such as using the leveling the ground will be cracking.


4.The base that tiling tile should be handled well to avoid ceramic tile empty drum, the metope of tile shop first, ground floor must deal with clean. Be sure to remove all kinds of dirt on the wall, and mention the water wet
5.When the cement mortar needs to be plump and evenly mixed with the back of the blade of the cement mortar, it should be noted that the cement mortar should be full and even and not cut corners.
6.Set aside 2-5mm expansion joints for tile tiling. If there is not enough expansion joint, under the action of thermal shock expansion or moisture expansion, the stress can occur between adjacent tiles, causing the empty drum to fall off.