Posts

How Removing Debris from the Floor?

/in /by


Sweep the floor with a soft broom. Take a soft dust mop or a broom with soft bristles and sweep the floor. Make sure to sweep up as much debris as you can. Pay special attention to areas along walls or doors.


Be careful using a vacuum. If you choose to use a vacuum, you need to be careful not to damage your marble floor. The plastic on the nozzle or wheels of a vacuum can etch or scratch marble. As a result, use caution if you decide to use a vacuum. If you have a central vacuum system in your home, you may be able to use a soft floor attachment on the nozzle. However, you should test the attachment in an inconspicuous area (such as behind a door) before using it.


Use rugs and mats throughout your home. Rugs and mats will help accumulate debris. As a result, sweeping or vacuuming your floor will be easy. In addition, rugs or mats will protect high traffic areas from scratches.


Put down rugs to protect your floors. Area rugs and floor runners can help protect your marble floors, especially in high-traffic areas. Use area rugs in places like the living room and rug runners in hallways to prevent scuffing and scratching. Adding a no-slip pad under your rugs will help further protect your floors and keep your rugs in place.


Apply additional layers the same way. After the previous layer is completely dry, wax the floor again. Remember to do it in sections and plan your route to the door. Your specific floor wax product should include a recommended number of coats. If it doesn’t, apply three or four thin coats. Stop if the wax starts turning yellow.

The Knowledge of Cut Tiles

/in /by

Dry-fit the tile over the flange to make sure it fits. Check your work before you attempt to secure the tile in place permanently. So long as your circular cutout is less than 0.5 in (1.3 cm) larger than the toilet flange all the way around, the base of the toilet should cover the cutout. Once you know the tile fits properly, you can secure it to the floor permanently.


Reach across the tile to the edge that’s farthest away from you and set the wheel of the scoring tool on the end of the guideline. If the glass tile is too large for you to reach over to the edge, stand alongside it instead while placing your scoring wheel.


Pull the scoring wheel toward you using the straightedge as a guide. Press firmly down on the glass with the scoring tool as you pull it towards you. It should make a distinctive crackling sound as the tool scratches the surface of the glass tile if you are applying enough pressure. Look to see a faint but definite line cut into the glass.


Grip the section of glass you want to cut with grozing or running pliers. Grozing and running pliers have a flat, serrated jaws that are perfect for gripping and breaking scored glass. Keep the tile face up on the workstation or table and grip the edge of the glass with the pliers positioned parallel to the cut you made with the scoring tool. If your pliers do not have a rubberized grip on the jaws, apply masking tape to get a better grip on the glass.


Snap downward to break off the tile. Position the scored glass tile so the edge of the tile that you want to snap off is hanging over the edge of the table or workbench. This will give you room to snap the piece off. In one swift motion, snap the glass downwards using the pliers to grip it. The glass should break cleanly along the line you scored. Don’t press down slowly or the edge of the glass may break off unevenly.

How to Polish Tile Floors?

/in /by

A well-polished tile floor can make a room feel clean and inviting. Whether you have ceramic, vinyl, stone, or any other type of tile flooring, giving your tile a shiny luster doesn’t have to be difficult, time-consuming, or costly. The keys to a polished tile floor are a clean and well-buffed surface and regular maintenance.

 

Dirty and discolored grout will stand out once you’ve finished polishing the tile, so it’s best to clean it well before you clean the rest of the floor. You may need to put in a little elbow grease and get down on your knees to scrub the grout well. Treat very dirty grout before you start scrubbing. Sprinkle baking soda over the grout, then spray vinegar onto it. Leave it to sit for 5 minutes before you start scrubbing.

 

If you have a lot of grout, it’s best to use a grout brush because it will be more efficient than a toothbrush. You can buy a grout brush for a few dollars at most department stores or online. Don’t scrub the grout so hard that it starts to flake or chip off! Use a mop to clean the whole tile floor. It’s important that you clean the tile floor well before you begin to polish it. Because you’re not using chemical soap, you don’t need to mix or slosh the water to create suds.

 

Dip your mop into the vinegar solution, wring out any excess water, and mop the floor in broad strokes. Work your way from one end of the room to the other, taking care not to miss any spots on the tile floor. Don’t forget any corners, cabinets or pantries. Apply club soda to remove any built up floor wax. Club soda is an excellent natural and environmentally-friendly wax-stripping alternative.

Fill a clean bucket with only club soda and scrub your tile with a brush to remove old wax. Then use clean water to mop up any residue and allow the tile floor to fully dry. For a stubborn wax buildup, you can let the club soda sit for a few minutes before you scrub it.

The Choose And Buy Method Of Balcony Tiles

/in /by

The balcony is the only extension of the house to the outdoor part, it is not only the best place for drying clothes, but also our busy life in a rare square of pure land. So how should we choose the balcony tiles?


1. Style selection
Now residents housing area is bigger and bigger, small size ceramic tile can not meet the requirements of household, indoor metope ceramic tile of general with 250 x 360 mm size is relatively common, sitting room ground brick is generally not less than 500 x 500 mm, if sitting room area is more than 40 square meters, the floor tile specification requirement is larger.
2. Color selection
Because of the balcony light is bright, especially some bearing better balcony, plus the balcony is to rest and cool clothes in the bedroom, need to be relaxed atmosphere, therefore in the balcony had better choose more shallow the color of the tiles, for example, light yellow, white, rice white, shallow black, etc. But it is not suitable for deep color, such as big red, dark brown etc.
3. Ceramic tile size
For small ceramic tile of the person you like, the balcony of a strip, can choose a small balcony to laying brick, brick or buy large balcony through the modification is allowed, as long as according to the length and width of the balcony, it is good to follow the laid, on the other hand, because the area of the balcony is original is not very big, small space to choose ceramic tile can foil more space dimension sense, like a fat man is suitable for vertical stripes clothes don’t look fat, thin people wear suitable for horizontal stripes appear thin is not a reason, so choose ceramic tile size small balcony is ok.