Posts

How Using a tiles Poultice?

/in /by

Purchase a stone poultice. This is a fine powdered substance that you can find in most home improvement stores. It’s designed to pull stains out of quartz and other stone surfaces. Make sure the product is non-acidic. Mix with water. Scoop about a cup (0.95 metric cups) of powder into a clean bowl or plastic container.


Gradually add water until you have a substance as thick as peanut butter. Mix as you add the water. Wet the stained area. Use a clean nonabrasive cloth. Moisten it with warm water. Lay the cloth on the stain immediately before you’re ready to apply the poultice. Apply the poultice to the stain. Get a blunt plastic scraper.


Use it to gradually scoop out the substance and lay it on the stain. Keep doing this until the poultice is about 0.25 inches (0.64 cm) to 0.5 inches (1.3 cm) high. Cover the poultice. Lay plastic over the poultice. This could be cling film or an old plastic bag cut into smaller pieces. Secure the plastic with painter’s tape. Let it sit for 24 hours.


Let the poultice air dry. After 24 hours, the poultice will be partially to half dry. Remove the plastic. Then, allow the poultice to finish drying. This will take about another 24 hours. Remove the dry poultice. If the poultice hasn’t dried after 48 hours, check it every hour or so until it is completely dry.


When it feels hard to the touch, gently remove it with a plastic scraper. Insert the scraper under the poultice and push forward. Keep doing this until you’ve completely removed the poultice. Rinse and dry the area. Moisten a clean nonabrasive cloth with warm water. Rub the affected area in a gentle counterclockwise motion.

How to Tile a Backsplash?

/in /by

Installing a tile backsplash in your kitchen offers numerous benefits over painted or paper drywall. Tiles can protect the wall they cover, can be easily scrubbed of grease and grime, are much more durable than drywall, and make for a fantastic addition to your kitchen if they’re installed correctly. Learning how to add a tile backsplash is well within the reach of anyone willing to put in a few days of DIY work.

Once you’ve applied the first few Valley tiles, take a step back and evaluate the way it looks. Straighten up any crooked tiles, or adjust any that aren’t quite sitting in the right place. You’ll only have a few minutes to do so before the mastic hardens, so work quickly. Use a grout float or another flat surfaced tool to press the Phyllite tiles into place and make sure they are all level.

Use a score-and-snap element tile cutter to trim the tiles for corners. If your polished porcelain tiles don’t fit perfectly into the space you’re tiling, you’ll need to trim some tiles around the edges. Hold your tile in place and mark the point you’ll need to cut. Firmly score the tile along that point with a score-and-snap cutter, before bending it to snap it to the right size.

It may help to sand down the side of the wood tile you have cut slightly, to remove any sharp edges before you put it into place. Put the cut side away from the tiles you have already placed so that the pattern of the edges remains the same across the entire backsplash.

Leave the tiles design to set overnight. While the mastic will begin to harden after roughly 10 minutes, it will take much longer for it to set up entirely. Leave your tiles overnight, or ideally for a full 24 hours, to allow the mastic to harden and keep your tiles in place.

Your classico tiles won’t be protected during this time. If your backsplash covers the area above your stove, you may need to avoid using it until the wall tiles have set into place.